Features: 性能特點
l Up to +/- 7000V(DC+Peak AC) Differential
l Bandwidth up to 70MHz
l Safety Certified
l Overrange Indicator
Applications: 應用
l High Voltage Floating Measurement
l Voltage Surge Measurement
l Electronic Ballast Design
l Power Electronics System Design
技術參數
| Bandwidth | DC to 70MHz (-3dB) |
| Attenuation | 1:100/1000 |
| Accuracy | +/- 2% |
| Rise Time | <5ns |
| Input Impedance | 50Mohm//10pF each side to ground |
| Input Voltage | |
| -Category | CAT I |
| -Differential Range* | +/- 700V(DC+AC Peak) and 500Vrms @ 1/100 +/-7000V(DC+AC Peak) and 5000Vrms@1/1000 |
| -Common Mode Range* | +/-7000V(DC+AC Peak) and 5000Vrms @1/100 & 1/1000 |
| -Absolute Max. Voltage* | +/-7000V(DC+AC Peak) and 5000Vrms @1/100 & 1/1000 |
| Output Voltage | |
| - Swing (into 50kohm load) | +/-7V |
| -Offset (typical) | <+/-5mV |
| -Noise (typical) | 0.9mVrms |
| -Source Impedance (typical) | 50 ohm (for using 1Mohm input system oscilloscope) |
| CMRR (typical) | -80dB @50Hz, -60dB @20kHz |
| Ambient Operating Temperature | -10 to 40 degree centigrade |
| Ambient Storage Temperature | -30 to 70 degree centingrade |
| Ambient Operating Humidity | Up to 85% RH |
| Ambient Storage Humidity | Up to 85% RH |
| Power Requirements | |
| -Standard | 4xAA cells or 6VDC/200mA mains adaptor** or regulated 9VDC/120mA mains adaptor** |
| -Options | Power leads |
| Length of BNC Cable | 90cm |
| length of Input Leads | 60cm |
| Weight | 500gms |
| Dimension(LxWxH) | 202mm x 83mm x 38mm |
*Voltage limit is the lesser of the DC+AC Peak and RMS values.
** a. The supplied voltage must be less than 12V and greater than 4.4V, otherwise the probe could be damaged or can't be operated properly.
b. polarity is "+" inside and "-" outside. For wrong polarity, built-in circuit protects the probe, no danger or damage will occur.
c. When the voltage of the cells become too low, the power indicator on the panel will flicker.
** a. The supplied voltage must be less than 12V and greater than 4.4V, otherwise the probe could be damaged or can't be operated properly.
b. polarity is "+" inside and "-" outside. For wrong polarity, built-in circuit protects the probe, no danger or damage will occur.
c. When the voltage of the cells become too low, the power indicator on the panel will flicker.
:
在訂貨前*好還是致電我們，以確定貨期和數量。
/ /
本標題頁面：SI-9010A差分探頭
所有評論僅代表網友意見，與本站立場無關。