該 IC 旨在滿足低功耗要求，因此使其成為電池供電系統的理想選擇?？梢詫崿F(xiàn)低至 0.77μA @ 1Hz 轉換率的平均電流消耗。有七種不同的過采樣率 (OSR) 選項可用于電容和溫度測量，從而可以優化分辨率、轉換速度和電流消耗。

MAS6513 可以基于命令（一次性模式）或自動（連續模式）運行測量?？蛇x的中斷輸出可配置為在新結果可用或任何結果超出可編程警報限制時發出中斷。

MAS6513 提供裸片和小型 DFN-12 3.75 mm 封裝。

MAS6513 is a capacitive sensor signal conditioner IC, capable to interface both single and dual capacitance sensors. It uses a 24-bit Capacitance-to-Digital Converter, which employs a delta-sigma (ΔΣ) conversion technique. The output can be proportional to capacitance difference, ratio or sum. In addition to capacitance measurement the device has temperature sensor which is capable of measuring temperature in wide -40°C … +125°C temperature range. Built-in 24-bit calculation engine produces calibrated high-resolution output which can comprise of up to 3rd order linearization and 2nd order temperature compensation of sensor capacitance value and up to 2nd order linearization of the on-chip temperature sensor signal. The device includes a 512-bit EEPROM memory for storing capacitive sensor front-end trim values and calibration coefficients on-chip. 184 bits are left free for any other use.

The IC is designed to meet the requirement for low power consumption, thus making it an ideal choice for battery powered systems. Average current consumption down to 0.77μA @ 1Hz conversion rate can be achieved. There are seven different oversampling ratio (OSR) options available for both capacitance and temperature measurement which makes it possible to optimize resolution, conversion speed and current consumption.

The MAS6513 can run measurements either commａnd based (One shot mode) or automatically (Continuous mode). Optional interrupt output can be configured to given an interrupt when new results are available or when any result has exceeded programmable alert limits.

The MAS6513 is available as dies and in a small DFN-12 3.75 mm package.