Enapter 的電解制氫機對進水的純凈度要求低，可以加入純凈的雨水或者自來水。使用樹脂過濾器的簡單反滲透過程可以提供所需的水質，輸入電解槽的水需要進行脫鹽處理，電導率應小于20μS/cm。

參數

進水                                                                                       自來水或者雨水

進水                                                                                       類型自來水或者雨水

進水的鹽度                                                                      2000 mg/L TDS

進水的壓力值范圍                                                                   2.5 - 5.0 bar

進水的溫度范圍                                                                      10 - 25 °C

出水                                                                                       <20 μS/cm (at 25 °C)

出水率                                                                                    1.3 L/min (with 500 mg/L TDS & 20 °C input water)*

電源                                                                                        AC 100-240 V, 50/60 Hz

運行功耗                                                                                 80 W

運行環境溫度范圍                                                                   10 - 35 °C

重量                                                                                        26 kg

安裝位置                                                                                 Place in enclosure next to cabinet. (Can be installed inside our cabinets upon special request)

可連接電解設備數量                                                                Up to 30

過濾系統                                                                                 反滲透系統結合混合床離子交換樹脂

維護                                                                                        維護間隔取決于使用情況和進水質量。Enapter 建議每月檢查一次水質。

                                                                                                ≡ 反滲透系統輸入過濾器：3500升水或運行6個月

                                                                                                ≡ 滲透膜和離子交換膜：取決于待處理水的鹽度和化學成分

（*）溫度降低和待處理水的鹽度增加會導致凈水量減少。